EyesWeb XMI Forum http://forum.eyesweb.infomus.org/ |
|
Delete the data on a port http://forum.eyesweb.infomus.org/viewtopic.php?f=25&t=98 |
Page 1 of 1 |
Author: | vnick [ 11 May 2009, 13:10 ] |
Post subject: | Delete the data on a port |
Hi, I have an EyesWeb patch that contains file reader and file writer and a module in between processing image data. I want to run the patch with a bunch of input files. That works fine in principle. Now my module in the chain needs a runin time of 3 images when the input file changes. Therefore I have added a file port to this module and have connected it to the file reader. When a new file is detected the first three images are skipped. Fine so far. Now the but: BUT: The file writer still writes out images and does not wait for the new ones to arrive even if I skip the whole processing thus the generation of new output data. This results e.g. if I run two sequences 10 images each with the first 3 to be skipped in the first output file to correctly have 7 images and the second output file to have 10, 3 old ones and 7 new ones. QUESTION: How can I avoid the file writer to be triggered again with the old data when I switch to a new file or in other words: How can I reset the output ports of my module that is connceted to the writer to the initial state they had at start time? Thanks a lot in advance Regards Volker |
Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |